Description
The FAHRER Motor Cover is a quality product designed to protect an e-bike's motor during transport on the roof or on a luggage rack mounted on the tow bar or tailgate. If you want to take your e-bike on vacation, it is often transported in or on a vehicle. Attached to the roof or luggage rack, the bike is exposed to driving rain and splashing water during use, which can penetrate the motor due to the high impact pressure on the housing. The MOTOR COVER PREMIUM, made of high-quality, elastic neoprene, protects your e-bike's motor during transport from weather influences such as driving rain and stone chips. This guarantees the motor's long-lasting functionality. The elastic material of the COVER allows for a precise adjustment to mid-drive motors from various manufacturers. Note: The Motor Cover is a transport protector and must be removed before riding. The Motor Cover is not designed to keep the motor housing dry. Holes in the bottom of the cover drain rainwater. If cleaning is necessary, we recommend hand washing with mild soap. Features: Suitable for any e-bike with mid-motor such as BOSCH, SHIMANO, IMPULSE, YAMAHA, BROSE, TranzX and PANASONIC Can be adjusted to individual frame and motor geometry. Correctly mounted, it fits tightly around your motor and frame and does not cause scratches like loose bags in the airflow while riding. The Motor Cover is a transport protection (must be removed before riding) and is not designed to keep the motor housing dry. Material: High-quality neoprene. Easy to install. Variable pedal position possible, left or right forward and approx. 45 degrees up or down to adapt to the rear carrier. Fits all e-bikes with mid-motor such as BOSCH, SHIMANO, IMPULSE, YAMAHA, BROSE, TranzX and PANASONIC Designed in Berlin and manufactured in the EU. Installation: Place the MOTOR COVER on the bike from the chain/belt side with the Velcro fasteners open. Place the large tab around the bottom of the bike and fold it over to the other side. Secure the flap with the Velcro fasteners. Finally, thread the top flap with the rider's logo between the frame's down tube and the bike, pull tight, and close with the Velcro fastener.
