Å Robust wheel truing stand is compatible with a wide range
range of wheel sizes and hubs.
Å Supports any wheel from 16" to 29", with or
without a tire.
Å Plastic coated brake calipers protect your
rims and open wide enough to accommodate thick
to be able to remove bicycle rims up to 80 mm wide.
Å The base can be placed freestanding on a workbench
left, mounted in a vice or
screwed in place thanks to the pre-drilled base plate.
Å Using Unior hub adapters you can
simple 20mm, 15mm, 12mm thru axle hubs and
Installing Cannondale Lefty wheels in the stand
for service.
Å Also storage space in the base for the
thru axle adapters, so that they are always at hand
are.
The IceToolz brake shoe adjuster is a great
Handy device. Suitable for various sizes
brake pads and rims. With the brake shoe straightener
adjust the brake shoe to the correct height,
distance to rim in the correct toe-in. The
brake shoe adjuster indicates by means of a
clear arrow indicating the front/direction of travel.
IceToolz article number of the
brake shoe straightener is 55B1.
The IceToolz brake shoe straightener is a tool for
professional and do-it-yourselfer. With the arrow towards
the direction of travel of the wheel over the rim
The ideal position for the brake pads is clamped
determine.
If the brake pads are completely parallel to the rim
If they are placed there is a good chance that they will
squeak. The brake pads should be toe-in
be placed. This means that the front
of the brake pads slightly closer to the rim
then point to the back. With this slant,
toe-in has already been taken into account
brake shoe adjuster. The front of the
brake shoe straightener is slightly thinner than the
back. The correct height can also be easily
can be determined with the brake shoe straightener.
Mount the brake pads against the top edge
of the brake shoe adjuster and the
brake shoe/pads are in the correct position.
Suitable for aluminium and carbon
cranks + disassembly bearings
Campagnolo power torque and ultra torque
Fulcrum ultra torque 1626A
complete set for assembly and disassembly
of crank arm and bottom bracket bearings
? 3 to 6 times more sustainable than conventional
steel files.
A hard chrome layer repels the filings
effectively, prevents clogging of the
teeth and ensures a clean cut.
Set of 5 pieces
Superior rust and corrosion resistance
Shimano TL-FC38 wrench
for assembly and disassembly
of the chainring lockring
suitable for STEPS
E6000, E6001, E6010, E6050
for using this tool
you need TL-FC32 or TL-FC36
or the TL-FC33 in combination with TL-MH10
